LED Guided Solutions
Applications that require illuminating fixture block cavities and
corresponding storage bins for guided assembly can be accomplished
with Dynalab LED Guided Test Point Boards. In addition, fixture
boards dedicated to detecting mechanical items (clips, grommets,
etc.) can also utilize these special test point boards.
There are three unique applications for the Dynalab LED Guided
Test Point Boards:
Connector Pinning
Fixture Blocks that have LED’s actually located in the cavities
to guide the operator where to insert the wire.
Application Note
Connector Pinning with Continuity
Electrical Fixture Blocks that have LED’s outside the connector
opening to guide the operator where to insert the wire. Then the
wire continuity is validated after assembly.
Application
Note
Detection Switches
Fixture Blocks that verify the presence of a mechanical item and
include an indicator LED
Application
Note
LED Test Point Boards
In order to take advantage of the LED Guided function, a NX Tester
needs to be equipped with LED Test Point Boards. LED Guided Test
Point Boards and Standard Test Point Boards and cannot be installed
in a NX Tester at the same time.
The LED Test Point Board can be purchased separately and installed
in any existing NX Tester. Part Number: 5-4009
A new NX Tester can be purchased with the LED Test Point Boards
installed. Specify a “-L” suffix when ordering. Example:
1-256-0-L

5-8825 |
Red LED with 6" leads |
|
5-8967 |
Power Supply, 5VDC, 4A |
|
|