Getting started with the NX System is as simple as selecting an NX Tester, ordering the Getting Started Kit, and selecting the appropriate fixture interface method.

Select the NX Tester based on the number of test points.

NX Solo

256 Test Points

NX Pro

512 Test Points

NX Pro+

32,768 Test Points

Essential Items
Dynalab has created a Getting Started Kit that includes all items required for a Dynalab System. This kit includes:
  • NX Editor and Download Cable
  • Memory Card
  • Memory Card Reader/Writer
  • Supervisor Key
  • Probe, 8'
5-1002 Getting Started Kit

Fixture Interfacing
NX System test point boards provide 128 test points per board, organized into 2 groups of 64 points each. Each group of 64 test points is accessible from the back of the Tester. A card edge connector is used to interface to a set of 64 test points. The card edge connector may be equipped with discrete wires or with a ribbon cable. Choose either discrete wire interfacing or ribbon cable.  
A discrete wire interface cable consists of 64 individual wires. Each wire runs directly from a test point to a fixture pin. It is less expensive than the ribbon cable solution.
Ribbon cables neatly deliver test points from a NX Tester to Terminal Block Interfaces. Fixture pins are wired to the Terminal Block Interface by screw terminals. Should a fixture block require maintenance, it can be unscrewed and replaced with a substitute in seconds.

Discrete Wire

Terminal Block